So I was about to overclock my monitor (MSI 24' 144hz) So i did 244hz and deleted the 1920x1080... nothing happened so i didnt do nothing about it. 4 hours then i got Blue screen, after my PC loaded, the colors on my monitor were faded and only 120hz. So i started to malé some Changes in monitor settings and Windows but it wasnt like previously. i added in CRU resolution 1920x1080 (set as auto, PC) 144hz i tried to apply IT and it showed "restart required" I restarted my PC and now it repeatedly shows no signal again and again 20 seconds it wants to load and then it writes "HDMI 1 no signal" and then theres blackscreen than it again shows the same and this Is the loop. My PC wont boot up and i dont know what to do... in worst i would do a factory reset but i dont know how because my PC wont start. PLEASE HELP
↧