Hey guys.
I've been trying to change the VRR range on my MSI MPG 321URX using CRU without any luck. I want to make it higher so the LFC will engage earlier.
If I use HDMI 2.1 and try to put anything higher than 48Hz in the HDMI 2.1 Support section the number goes red and I can't press "OK".
If I use DP connection and try to edit V rate in the "Edit" section of my monitor it doesn't work either.
I also tried to change device ID, no luck.
RTX 4090
Could someone please explain what's going wrong?
Thanks!
I've been trying to change the VRR range on my MSI MPG 321URX using CRU without any luck. I want to make it higher so the LFC will engage earlier.
If I use HDMI 2.1 and try to put anything higher than 48Hz in the HDMI 2.1 Support section the number goes red and I can't press "OK".
If I use DP connection and try to edit V rate in the "Edit" section of my monitor it doesn't work either.
I also tried to change device ID, no luck.
RTX 4090
Could someone please explain what's going wrong?
Thanks!